Engine preheater install 

Trying to fit a DEFA engine pre-heater. This is a thermo-element that goes in the engine block coolant (anti-frost) plug. At first i thought I had the wrong element but i removed the wrong plug (drain plug, instead of anti-frost plug). After getting the nut 36 size, it all went hunky-dory. And it works!

removing exhaust manifold give a little more room and view on both drain-plug and anti-frost plug.
removing exhaust manifold give a little more room and view on both drain-plug and anti-frost plug.
Viewed: 80 times.

starter on the fantastic location for problem analysing...
starter on the fantastic location for problem analysing...
Viewed: 79 times.

starter wires.
starter wires.
Viewed: 72 times.

plugs and starter
plugs and starter
Viewed: 71 times.

Viewed: 66 times.

removed drain plug.
removed drain plug.
Viewed: 68 times.

The Kit.
The Kit. "watercooker" element, plus wires.
Viewed: 78 times.

the size of nut we are talking about...
the size of nut we are talking about...
Viewed: 74 times.

Viewed: 72 times.

wasn't that supposed to get IN the bucket?
wasn't that supposed to get IN the bucket?
Viewed: 80 times.

element in the plug hole.
element in the plug hole.
Viewed: 81 times.

wire from the element to the front.
wire from the element to the front.
Viewed: 84 times.

now you can charge my car. :-))
now you can charge my car. :-))
Viewed: 100 times.

Powered by Gallery v1 - Collected by Jelger Groeneveld RSS